➤ Assist the software to configurate parameters on anchors and tags
➤ Assist device to power off without physical buttons
➤ Assist device to update firmware via OTA update
Operation of equipment settings
A、Insert USB dongle to PC
B、Find the setting application “Set.exe.”, select Device Set, find the corresponding serial port number of UWB Dongle and click Connect
C、To set anchor, first ensure that its power is on and click Search in Set to search for anchors around the area
D、To set Tag, first ensure that the power is on and click Search in Set to search for Tags around the area
Remote Shut down:
A、Insert UWB Dongle into PC
B、Find the setting application “Set.exe.”, select Device Set, find the corresponding serial port number of UWB dongle, and click Connect.
C、Click Start Reponse Tag Power Off to allow Tag to enter Power off mode.
D、Ensure Tag is within 5 meters to UWB Dongle to operate this function. This operation is only suitable for tag models without physical power buttons
E、Once complete, click Stop Response Tag Power Off or manually disconnect the USB dongle. This will prevent other tags from powering off.
Firmware Over-the-Air (OTA) update
1、Insert UWB Dongle to USB port and open RfUpdateApp.exe
2、Select corresponding serial port of the UWB Dongle, click Connect
3、Select firmware that requires device update (UWB Dongle, Tag, Anchor update possible), click Open File select corresponding firmware app.hex
Drive Test
Insert UWB Dongle to computer. When using UWB Dongle for the first time, computer may discover new hardware icon, if automatic installation failed or when unable to differentiate anchor at device manager, user can try manually install drive under drive file by DMATEK that corresponds to the system
Drive Installation Prompt
After inserting Usb Dongle, check first if drive installation can be automatically completed, check by seeing if serial port can be found under “port” in “device manager”.
Right click “My computer”, select “Manage”
Then select device manager on the left
Check whether there is “port” at right hand side, and check whether there is new sub-item of “ USB serial port”. If there are already a few serial port existing and user is unsure whether there are new ones produced, try removing USB dongle and insert again, serial port that disappear and reappear will be those that are produced by this USB Dongle
If “other device” is found here à “USB Serial Port”, this indicates that drive is not automatically installed, try using manual installation in this case
How to Install Drive
USB Dongle uses FTDI chip, user can use drive (..\Driver\UWB Dongle(FT232) that comes with the cyberspace or proceed to official website to download working system corresponding version (http://www.ftdichip.com/Drivers/D2XX.htm), select appropriate drive version according to users’ window version, connect to USB serial port after drive installation completed to find port number in Set.exe
Right click “USB Serial Port”, select “update device driver”, site as below will appear:
Select “Browse device driver” option
Select “browse”, find drive related file, click “next” then complete installation